Victory VF-3 User Manual download pdf (Page 4)

iii

Proper installation is the first step to operation. We recommend that your refrigerator or freezer

be installed by an authorized Victory Certified Installer.

Receiving Shipment

All units are performance tested and thoroughly inspected prior to shipment. Upon leaving the

factory, all units are in perfect condition. Upon receipt, examine the exterior of the shipment

packaging for any signs of rough handling. If the cabinet is damaged, it should be noted on the

delivery slip or bill of lading and signed. A claim must be filed immediately against the carrier

indicating the extent and estimated cost of damage incurred.

Uncrating

Tools Needed : 3/4” Box Wrench l Adjustable Wrench l Level

WARNING: Never lay your refrigerator or freezer down on either its back, front or sides. This

allows compressor oil into the refrigerant lines which can damage the compressor at start-up. If

the unit is laid down, it must be set upright for a minimum of 12 hours before starting the

compressor. Failure to adhere to the above recommendation will void the warranty.

1. Split plastic wrap along one of the cardboard posts. Remove and discard all packaging

material, tape and interior components.

2. Move cabinet as close to final location as possible before removing skid.

3. Remove the shipping skid by tipping the cabinet forward. Remove the shipping bolts with

3/4” box wrench while the cabinet is held in one direction. Repeat this procedure

while the cabinet is held in the opposite direction.

4. Use extreme caution when removing the wooden skid, especially when the last bolt is

removed. If not properly blocked, the skid will fall to the floor.

Locating Your New Storage Refrigerator or Freezer

Consider the following when selecting a location for your refrigerator or freezer:

1. Clearance - There must be a minimum clearance of 10” between the top of the refrigerator

or freezer and the ceiling.

2. Floor Load - The floor on which the cabinet will rest must be free of vibration and suitably

strong enough to support the combined weights of the cabinet plus the maximum product

load.

3. Ventilation - The air cooled, self-contained refrigerator or freezer requires a sufficient

amount of cool, clean air. Avoid placing the refrigerator near heat generating equipment

INSTALLATION INSTRUCTIONS

1 2 3 4 5 6 7 8 9 ... 15 16

No comments

Victory VF-3 User Manual Page 4